#Picking a master lock combination how to

All the pins will be on the top half of the lock, so focus on putting the tension on that part. Then, start to find the first pin and push it up. In this step, make sure the wrench remains fixed at the shear line. This is a vital step that many people can successfully unlock the first time. Repeat this step a few times slowly to make sure you hear the jingle from the springs of the pins. Make sure to apply enough force to the pins so that it aligns with the shear line for best results. All you need to do is turn the bent tip up to make contact with the pins. Insert the pick into the deepest position to feel the height of the pins. Step 4: Determine the position of the pins At this point, the wrench will act as a lever. The important thing is that it should be right at the shear line. However, if the key does not move when rotating clockwise, then the direction of the spindle will be in the opposite direction.Īfter knowing the direction of rotation, leave the wrench as low as possible and as deep as possible.

Most of the spindles I know usually rotate clockwise. Insert the wrench into the keyhole to test the flexibility of the spindle. Take half of the piece you just assembled, including the piece that it was placed on, at 90 degrees to an L shape. Then, use the plier to flatten the loop that appears after you bend it. Now, use the plier to bend about one-fourth or third of the paper clip onto itself. Third, turn to the second paperclip, which works as the tension wrench.

Then, push the rest of the paperclip to the left for about 45 degrees, which only requires a few millimeters of the tip. Second, insert the paperclip into the keyhole about 1 centimeter. Step 2: Reshape the paperclipįirst, you need to use the plier to straighten the paperclip into a long metal bar. However, I believe this will help you a lot in bending or straightening parts of the paperclip without hurting your hand. Meanwhile, the other will function as a pick to lift the pins and shape the paperclip.Ī plier: Many people think that we do not really need this tool.

Two paper clips: One will act as a wrench to apply pressure to the lower pins and turn the spindle. If you’re not a locksmith, it’s a waste to buy a lockpicking kit, then leaving it at home or always taking it with you.

#Picking a master lock combination how to

How to Pick a Master Lock with a Paperclip Step-by-Step Process At the same time, another paperclip will be used to rotate the spindle to turn the lock in the predetermined direction. We will use a paperclip to hook into the hole, pushing the pins up from this principle. When the key is inserted, the serrations on it assist in pushing the springs up, repositioning the pins, and recreating the shear line. In the locked state, the upper and lower latches inside the lock are jumbled together, losing the shear line in the middle. These pins have different heights, that’s why each key has a different shape.

So, the more pins a lock has inside, the higher its security. You can see that there are serrations on each key, each of those will fit into a pin. Each master lock will be made up of three major parts: a set of pins, springs above, and a spindle where we insert the key. To open a lock, you need to know its operating principle.

Step 6: Continue with the remaining pins.

Step 4: Determine the position of the pins.

Step 3: Determine the rotation direction.

How to Pick a Master Lock with a Paperclip Step-by-Step Process.